Thomann SK140 Jack mono Angled

965

6.3 mm Mono Jack Angle Connector

  • Maximum cable diameter: 7.14 mm
  • Metal connector
  • High quality
Fås siden Maj 2000
Artikelnummer 128508
salgsenhed 1 stk
Installation No
Mono/Stereo Mono
Angled Yes
Type TS (mono/unsym.)
Plug Jack 6,3 mm TS male angled
7,50 kr
Inkl. moms. Obs! Yderligere fragtomkostninger 60 kr
Mængderabat
Stykpris Du sparer Mængde
7,50 kr 1
7,19 kr 4,1% 10
6,69 kr 10,8% 50
på lager
på lager

Produktet er på lager og klar til afsendelse.

Information om forsendelse
Forventet levering mellem torsdag, 4.04. og fredag, 5.04.
1

965 Kundebedømmelser

4.5 / 5

Du skal være logget på, for at kunne vurdere et produkt.

BemærkVi tillader kun vores kunder, at afgive en vurdering af det udstyr de har købt hos os. Vi modtager ikke anmeldelser eller vurderinger af produkter fra tredje kilde.

Efter login finder du også i kundencenter under "vurderinger af produkt" alle artikler, som du kan afgive en vurdering af.

forarbejdning

392 Anmeldelser

J
Good plug
JensWel 10.02.2021
For a tight home-studio setup (in a rack-like box) these plugs are a must. They work and give no hearable degradation to the sound.
0
0
Anmeld bedømmelse

Anmeld bedømmelse

A
Okay kvalitet.
Anonym 22.04.2016
Ikke det bedste, men heller ikke det værste.
0
1
Anmeld bedømmelse

Anmeld bedømmelse

google translate gb
Der opstod en fejl. Prøv igen senere.
W
Thomann SK140 Jack mono Angled
WD555 30.04.2017
Thomann SK140 Jack mono Angled
I have used these Thomann mono angled jacks many times before and they are in my opinion the best value in angled jacks.
Much cheaper than the big brand name jacks and really very good quailty for the price paid.
The metal outer casing is robust and I have never had any damage to them.
The outer casing screws over the inner part and the threads are well cut without any rough edges - the two parts do unscrew quite easily and I have taken to adding a little locktite thread locker o these threads to stop them from unscrewing in use but obviously only after I have tested the final cable is working !!!
Inside the outer cover is a thin plastic sleeve which slides over the connection to prevent the inner core terminal shorting to the ground cover.
The terminals are easily soldered and the outer clamp is easy to form with a crimping tool or carefully with needle nose pliers.
I add 75mm of heatshrink tubing to cover the side joint, again only after the vale has been tested, this protects the joints and also adds some protection in the form of relieving cable strain where the cable enters the housing, this technique is used on the "pro snake" cables which I believe also use the same angled mono jack plugs.
If you are using these jacks to make patch cables for a pedal board and want the angled jacks to be as close as possible (together, back to back ) then two jacks will require approximately 32mm space between pedals.
forarbejdning
2
0
Anmeld bedømmelse

Anmeld bedømmelse

google translate gb
Der opstod en fejl. Prøv igen senere.
A
Excellent price?performance ratio
Anonym 11.02.2017
Feedback for "Thomann SK140 jack mono angled"
A very cheap angled jack but do not let the low price fool you, it's a very decent little jack indeed.
These are the same jacks that are used on the "Pro Snake Patch - Professional Angled Jack Patch Cables".
All metal housing, they are not the prettiest jacks but quite solid and built to last.
I use the Pro Snake Patch leads on my pedal board but needed some longer leads to run from the board to my amps.
I have been experimenting with double, triple and even quad amp rigs recently and needed some extra cables but wanted to keep the cable runs to an absolute minimum so I cut up some old whirlwind cables that were far too long and was able to make them the exact length then used these angled jacks to complete the job.
The angled jack is great with pedals as it greatly reduces the space needed on pedal boards but I like to use the angled jacks going into my amps as it reduces the strain on the input sockets.
They are very easy to use and I will be ordering more soon to shorten cable runs and tidy my pedal board as soon as I have it completed.
So far I haven't had any problems with them, the only minor complaint is that the outer cover comes loose quite easily, it's no great problem but I think I will try a little low strength thread lock just to keep them from coming loose.
2
0
Anmeld bedømmelse

Anmeld bedømmelse