Marshall DSL100HR

50

Amp Head for Electric Guitar

  • DSL Series
  • Power rating: 100 W
  • Tube equipment: 4 x ECC83 and 4 x EL34
  • 2 Channels: Classic Gain and Ultra Gain
  • Independent volume and gain control for both channels
  • Clean and Crunch Modes in Classic Gain Channel
  • Lead1 and Lead2 modes in Ultra Gain channel
  • Classic tone control with bass, middle and treble
  • Presence control
  • Tone Shift circuit
  • Variable resonance control
  • Adjustable deep switch
  • Pentode/Triode switching
  • Digital reverb independent for each channel
  • Speaker Outputs: 5 x 6.3 mm Jack output jacks (16 Ohm / 8 Ohm /
  • 4 Ohm load capacity)
  • Dimensions (W x H x D): 740 x 274 x 242 mm
  • Weight: 24.2 kg
  • Includes power cable and foot switch PEDL-90012
  • Compatible with PEDL-91016 with the modes: 1 - Clean (Classic Green) 2 - Crunch (Classic Red) 3 - OD1 (Ultra Green) 4 - OD2 (Ultra Red) 5 - Master 1/Master 2 (Toggle) 6 - FX Loop on/off
Myynnissä vuodesta Tammikuu 2018
Tuotenumero 422016
Myyntierä 1 kappaletta
Power 100 W
Power Amplifier Tubes EL34
Channels 2
Reverb Yes
Footswitch Yes
799 €
Kaikki hinnat sis. ALV:n
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
llmainen toimitus. Arvioitu toimituspäivä Keskiviikko, 24.04. ja Torstai, 25.04. välillä.
1

50 Asiakkaiden arviot

4.6 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Käyttö

Ominaisuudet

Ääni

Työnjälki

38 Arvostelut

S
The best of the DSLs
Spiidi 31.12.2021
I have owned JCM2000 DSL100, the DSL100H, the DSL40C and now the DSL100HR. All the "flaws" which I didn't like on previuous models has been fixed on DSL100HR:
1. The ultra gain channel is tight, not buzzy and loose when chugging.
2. The shared eq is better balanced between channels.
3. There's a a second master volume setting for solo boost.
4. You can dial all channels clean, crunch, od1 & od2,master volume and loop with seperate foot switch.

I have read bad about Marshall's "Made in Vietnam" quality but I haven't noticed any quality problems compared to the UK made ones.
Käyttö
Ominaisuudet
Ääni
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

R
Loistava !
Rauli58 27.01.2023
Kerrassaan loistava tuote. Kaikki osa-alueet kunnossa.
Käyttö
Ominaisuudet
Ääni
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
D
Awesome entry Marshall amp!
DoomsEve 11.01.2022
I have to start off with stating that this is my first tube amp (although i have played other tube amps before). That being said i have to say that i really really like this amp. Its amazingly "fat" in the low end even with a single v30 speaker in 50W mode, although i feel that it does need a boost even in the od 2 setting to get all the agressivenes out of the amp. The clean is nice, and going with the crunch mode plus an BOSS SD1 it goes towards a nice JCM 800 type of sound. Only con for me is that its very big and chunky, kind of getting why people love the EVH 5150 50W amp being smaller than most full heads. In conclusion, great amp, great sound, a little big and chunky to move around when you have to, and the built in reverb leaves a LOT to be desired, but then again you have a free reverb built in... so yeah whatever!
Käyttö
Ominaisuudet
Ääni
Työnjälki
3
1
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
B
All in all, great amp !
Banjezzi 03.02.2022
When the amp arrived, i decided to take it to my technician right away to inspect it, change tubes etc, like i always do with new amps.
I definitely wanted to try it before it went to the technician, and it sounded great right away, but after half an hour i noticed it was getting too hot, anyway, i tried different channels and when i pressed the master button one of the tubes blow off, i heard a loud pop and i immediately turned the amp off.
Took the amp to the technician, and the first thing he did, he measured the voltage in tubes.
So ,left side was 80 mV, and the right side was 40 mV (while the tubes are marked at 51 mV, obviously they are not) and that's why they were so hot.
Then he realized that the tube sockets are wobbly.

To shorten the story , he replaced all tube sockets and all the tubes (puts in a Mesa Spax ECC83 in preamp and original Marshall EL34 in power amp), did the bias thing, puts all the tubes exactly to 50 mV, and now this DSL kicks ass.
Sounds great, feels great, and it looks sexy :D

I recommend that whenever you buy a new amplifier take it away to your technician or someone who knows what he's doing, to be sure what is going on
Käyttö
Ominaisuudet
Ääni
Työnjälki
0
4
Raportoi ongelmasta

Raportoi ongelmasta

Liittyvät YouTubesta