Behringer DI4000 V2

18

Active 4-channel Di-Box

  • Level shifter
  • Gain switch +20 dB for pre-amplification of low-level signals
  • Switchable phase
  • Switchable high-cut filter (8 kHz) for guitars
  • Ground lift switch
  • 4 x XLR and jack inputs
  • 4 x Jack link outputs
  • 4 x XLR outputs
  • Impedance: 240 ohms
  • Max.output level: + 20dBu
  • Frequency response: 23 - 69,000 Hz
  • Installation depth: 136 mm
  • Design: 19" / 1 U
  • Weight: 2.1 kg
Myynnissä vuodesta Heinäkuu 2020
Tuotenumero 493028
Myyntierä 1 kappaletta
Multi-Channel Unit Yes
Channels 4
Active / Passive Active
19" Yes
Pad switchable Yes
Gnd/Lift switchable Yes
Powered by battery No
Speaker Simulation No
166 €
Ilmainen toimitus sis. ALV:n
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu lähetyspäivä Perjantai, 26.04. mennessä
1

18 Asiakkaiden arviot

4.4 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Ominaisuudet

Ääni

Työnjälki

9 Arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
R
Not Good for Instruments
RelaxWithRiffs 08.09.2021
Editing this review:

At first, I disliked this DI box - since it seemed to warm the low end a lot. However, once I learned how to use the onboard features (ground lift, pad etc) the sound clean up tremendously.

So 50/50 - I was a little unfair initially, but also the design could probably be improved to be more intuitive.
Ominaisuudet
Ääni
Työnjälki
1
1
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
FF
Works well for my purposes
Frank Flanagan 25.04.2021
I am using this to interface with the TRRS (intended to be used for phone) I/O of a Rodecaster pro, which is otherwise very sensitive to ground loop noise.

Rode AI-1 monitor outputs -> two channels of the Berringer DI -> TRRS audio inputs.
TRRS audio output -> Berringer DI -> ATEM Mini video switcher.

Ground lift on all channels almost completely eliminates horrible ground loop noise.

I am using the +20 dB on 2 channels and the sound remains quite clean.

The sound is not quite as clean as some of the really high end DIs but god value for money and does the job well.
Ominaisuudet
Ääni
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate de
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
T
Preiswert und gut
T.Banks 29.07.2020
Ich nutze die DI4000 V2, um von den Klinkenausgängen eines Sound-Moduls auf XLR zu kommen. Habe die Box auf der Rückseite meines Racks eingebaut und hab so perfekten Zugang zu den Buchsen, um zur Stagebox zu verkabeln. Die DI-Box ist schön leicht und nicht so tief wie der Vorgänger. Ich konnte bislang kein Rauschen oder ähnliche Störungen entdecken...funzt einwandfrei.
Ominaisuudet
Ääni
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate fr
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
j
jojoblues59 22.03.2021
si on branche une guitare electrique directement sur le DI4000V2 le son est bon.
mais si on branche la guitare sur une pédale et sortie pédale sur le
DI4000V2 le son n'est pas net et ça grésille dans les hp.
Ominaisuudet
Ääni
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta