Allparts Audio Taper 500k Push/Pull Pot

143

Audio Taper Push/Pull Potentiometer

  • Logarithmic 500 kΩ potentiometer
  • Push/Pull switching function
  • Knurled shaft with standard length
  • Thread height: 9 mm
  • Thread diameter: 9.4 mm
Myynnissä vuodesta Kesäkuu 2016
Tuotenumero 388509
Myyntierä 1 kappaletta
Design Audio Taper
Resistance Value 500 kOhms
Characteristic Curve Logarithmic
Thread Length 10,0 mm
Tandem Poti No
Push/Push Push/Pull
Solderless No
shaft type grooved
10,90 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Maanantai, 29.04. - Tiistai, 30.04.
1

143 Asiakkaiden arviot

4.6 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

75 Arvostelut

A
Laadukas peruspotikka
Tuntematon 25.01.2017
Allpartsin osat tuntuvat olevan tasaista laatua ja kestävät hyvin käyttöä. Ainakin telessä olevat potikat ovat toimineet jo kolmatta vuotta ilman ongelmia. Suosittelen.
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
B
Good push pull pot
Belgian 17.09.2018
I used this pot to replace the old volume pot in my Mexican blacktop telecaster

Pros:
fairly easy to solder
the grounding lip on the bottom makes wiring a breeze
satisfying operation of the push pull switch
Cons:
didn't fit my telecaster control plate, but drilling out the holes bigger solved that easily and the washer disguises that perfectly

I Would consider buying this again if I need another p/p pot
Työnjälki
2
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
M
Mateii 31.08.2020
They do the job, and they come with double nuts for height adjustment. They soldered relatively easily and I used them to wire a HSH pickguard with P-Rails for a ST guitar.

I three of them in order to achieve the Rail/P90/Humbucker series/ Humbucker parallel, and neck tap sounds. Very versatile.

They started being a bit scratchy after 2 years
Työnjälki
3
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
WF
Potentiometer
Wow Factor 03.06.2022
It is a good quality potentiometer that i don't have any problems with. One thing to consider if buying one is that it is slightly larger than a normal potentiometer.
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta