Allparts End Pin Jack Chrome Acoustic

76

Endpin Socket for Acoustic Guitars

  • With 3 outer screw holes
  • Approx. 16.5 mm from centre to centre of the screw holes
  • Stereo
  • EP-4605-010
  • Finish: Chrome
  • Suitable screws: Art. 212575 (not included)
Myynnissä vuodesta Elokuu 2008
Tuotenumero 216695
Myyntierä 1 kappaletta
Type Trim Jack Socket, Stereo
Colour Chrome
12,90 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Torstai, 2.05. - Perjantai, 3.05.
1

76 Asiakkaiden arviot

4.6 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

31 Arvostelut

JK
Ehdottoman järkevä
Jaska Kunnas 20.07.2022
Tämmöinen jakki on paljon fiksumpi kuin mutterilla kiristettävä. Tämä ei löysty, ja hihnakin sopii ilman että reikää tarvitsee laajentaa.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

c
Hyvä jakki akustiseen
customshop 05.04.2023
Sopi helposti Yamaha APX-500 kitaraan alkuperäisen paikalle ja toimii hienosti.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
L
Very good quality
Lockhart 02.03.2021
General impression:
It holds perfectly and it looks better than the original it was replacing. Also, it is very sturdy when used to hold one side of the guitar strap. Much better than the ones that have no screws (as those ones keep loosing them self as you use them.

Cons:
You need to remember to buy the screws if you do not have them already. I forgot (my fault) but found them immediately in a nearby hardware store.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
Replacement for Takamine EN10
Tuntematon 04.06.2016
I bought this as a replacement for the endpin jack of my Takamine EN10 and fits perfectly - the three retaining screw holes line up, no additional work required to fit.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta