A
Was expecting more
Overall..poor craftsmanship with hammered corrections and slightly crooked joints on some places allover in the item...i did spent some time realigning stuff left and right, just for the looks...but most importantly...my 3U controller was sitting too low on the pre-drilled holes blocking the case joints and lid did not close at all for that...
Redrilling the holes further up just enough did the trick, but now controller upper edge is almost touching the wood surface of the lid, making stacking the case among other staff questionable....in other words the rack base wood inside the controller sits on, either needs trimming or replacement for peace of mind and road abusing the case. On top of that....whole lids right side was slightly misaligned on closure, compared to the left that was properly fitted...
i should have bought the Thomman case for 25 euro more, seems a much better quality choice really, after revisiting its page.
Redrilling the holes further up just enough did the trick, but now controller upper edge is almost touching the wood surface of the lid, making stacking the case among other staff questionable....in other words the rack base wood inside the controller sits on, either needs trimming or replacement for peace of mind and road abusing the case. On top of that....whole lids right side was slightly misaligned on closure, compared to the left that was properly fitted...
i should have bought the Thomman case for 25 euro more, seems a much better quality choice really, after revisiting its page.
1
0
Raportoi ongelmasta
m
It does what is says it does
You get what you see in the photos. No rack rails, just 2 pieces of wood to hold down your controller. It is road worthy, it is an inexpensive case meant to accommodate an inexpensive dmx controller, all is good here
0
0
Raportoi ongelmasta
