Hicon HI-J35T02

70

Jack

  • 4 - Pin 3.5 mm
  • With gold-plated pin
  • Maximum cable receiving 8.4 mm
  • Black housing
Myynnissä vuodesta Elokuu 2011
Tuotenumero 268945
Myyntierä 1 kappaletta
Build In No
Type TRRS
angled No
Plug Jack 3,5 mm TRRS male straight
6,50 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Torstai, 2.05. - Perjantai, 3.05.
1

70 Asiakkaiden arviot

4.3 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

34 Arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
M
Small and fiddly, but otherwise perfect
Matt.S 20.03.2020
Great quality connector for replacing the jack on headphones that include a microphone. Keep in mind when soldering that you'll need a pretty small tip to avoid melting the plastic. Also the sleeve for the cable is pretty big, a lot of modern headphones have ridiculously thin cables. So factor that in... Otherwise, great product.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
FF
Good quality and robust
Frank Flanagan 25.10.2021
Takes a decent size cable if you discard the rubber boot and replace it with thin heatshrink, which also probably provides better strain relief. I am using a bunch of these with 6.15 mm diameter cable.

You do need a fine soldering iron tip and ideally a decent wattage iron so the connector is only heated for a couple of seconds.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
TS
okey...
Tom S 03.04.2018
I used this jack to repair my earbuds.

I soldered the jack to my earbuds only i forgot to put the jack end on the cable before hand. So I had to desolder it the problem with that was that the plastic started to melt and 2 solder joints connected because of that.

Pro's
It's what it says it is

con's
weak design
Very large
1 chance to get it right
expensive
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
Good jack, noiseless
Tuntematon 26.09.2016
I bought the HICON HI-J35T02 Jack and I'm using it for my headphones in my home studio. I used a lot of 3,5 mm jacks but this one's the best in therms of sound. It's easy to attach to the cable and it doesn't have any noise. This Jack is awesome for the gold-plated connector which a perfect, noiseless sound. I didn't had any problems, it works great!
I recomand it to all the musicians looking for a perfect, noiseless and fine sound!
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta