K&M 23840 Microphone Arm

62

Flexible Table Microphone Boom Arm

  • 3/8" to 5/8" threaded connector
  • Max. load: 0.8 kg
  • Clamping range: 10 - 51 mm
  • Length: 460 - 960 mm
  • Material: Steel
  • Weight: 1.38 kg
  • Colour: Black
  • Suitable table flange: Article Nr. 158140 (not included)
  • Includes 4 cable clips
Myynnissä vuodesta Heinäkuu 2020
Tuotenumero 497308
Myyntierä 1 kappaletta
Type Microphone Boom
Height 460 mm – 960 mm
Colour Black
Weight 1,4 kg
Näytä enemmän
59 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu lähetyspäivä Perjantai, 26.04. mennessä
1

62 Asiakkaiden arviot

4.5 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Vakaus

Työnjälki

35 Arvostelut

A
Very Good
AudioMan- 07.08.2021
Been using it for years and it holds AT2020 and Rode Procaster quite well.
Työnjälki
Vakaus
0
0
Raportoi ongelmasta

Raportoi ongelmasta

J
Awesome stand
JasperDixon 24.08.2021
This thing feels like a freakin' tank compared to my 4 years old 15 bucks chinese stand. Amazing quality.
Työnjälki
Vakaus
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
D
Noisy and instable
Djangi 06.11.2020
When using a lighter mic (sm57) the springs tend to be too strong. This can be partially solved by tightening the clamps in the joints.
When using a heavier mic (sm7b) the springs are not strong enough, it's almost impossible to retain a 90 degree angle (it usually falls back to 75).
The spring are also very noisy which can affect your recordings.
The mic connector is too close to the joint for use with a SM7B which causes stress on the cable/connector. you can solve this with an extender like the Shure A26X.

Unfortunately I noticed most of the issues after spending quite some time with it, would have returned it otherwise. I'm probably going to replace it with the Rode PSA-1.
4
2
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
Solid.
Abdstract 19.08.2022
It does the job, good quality, stable and solid.
Työnjälki
Vakaus
0
0
Raportoi ongelmasta

Raportoi ongelmasta