Millenium DA-250/257 Percussion Holder

62

Double Percussion holder

  • To screw onto tripods
  • Multi clamp with two angled support rods 9.5 x 240 mm
Myynnissä vuodesta Huhtikuu 2009
Tuotenumero 224059
Myyntierä 1 kappaletta
26 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu lähetyspäivä Perjantai, 19.04. mennessä
1

62 Asiakkaiden arviot

4.5 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Käsittely

Vakaus

Työnjälki

20 Arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
P
Percussion holder
Peter3158 06.07.2015
I've had this about one week at the time of writing and have used it for a few rehearsals, no gigs yet. To fit it to a cymbal stand you have to loosen a wing nut and lift a bar then put it around the stand, put the bar back into place and tighten the wing nut. It can be a little tricky to get the washers on the wing nut in the right place but once done it is tight and secure. The angled arms are great for holding percussion. I could fit two cowbells and a wood block on one arm. When I unpacked it I could see that one arm was missing so I contacted Thomann who emailed me back straight away and have posted a new arm to me which should be arriving very soon. Good service! Update - the new arm arrived within a few days, posted from Germany to Scotland. GREAT service!
1
0
Raportoi ongelmasta

Raportoi ongelmasta