C
Great addition for 18950
I use this pair of stackers on stage to support a 61 note synth over the top of a larger synth on the main stand.
The stackers are adjustable either for ease of playing or for visibility so that you don't obscure the bottom synth too much. This is done by either moving them up or down or adjusting the angle of tilt. This must be set prior to playing as it cannot be adjusted with the synths in place.
Initial setting up to ensure the stackers are level can be fiddly but once I realised that I needed to simply revolve one of the stackers through 360 degrees to match its positioning with the other it was fine. You will see what I mean.
The built in support pins are rogust and hold the top synth in place very well. However the stackers do not adjust for width and it is important to balance the top synth. Over enthusiastic playing at one end of the keyboard can move the synth vertically as it overbalances slightly but knowing this means you simply take a little care.
Otherwise this product together with the main stand it fits into is easily one of the most robust and secure on the market. Highly recommended.
The stackers are adjustable either for ease of playing or for visibility so that you don't obscure the bottom synth too much. This is done by either moving them up or down or adjusting the angle of tilt. This must be set prior to playing as it cannot be adjusted with the synths in place.
Initial setting up to ensure the stackers are level can be fiddly but once I realised that I needed to simply revolve one of the stackers through 360 degrees to match its positioning with the other it was fine. You will see what I mean.
The built in support pins are rogust and hold the top synth in place very well. However the stackers do not adjust for width and it is important to balance the top synth. Over enthusiastic playing at one end of the keyboard can move the synth vertically as it overbalances slightly but knowing this means you simply take a little care.
Otherwise this product together with the main stand it fits into is easily one of the most robust and secure on the market. Highly recommended.
2
1
Report
A
Sturdy and easily adjusted.
I bought these to add an extra tier to my K&M 18950 and these couldn't be simpler to use - just slot them into the main stand, fixing them into place and then set your height and angle.
You can also adjust how far forward they extend over your existing keyboard, so you can have the upper one further back, to allow easier access to any surface controls.
The ends have a rubber-capped stopper, so your keyboard won't slip off if you have it tipping down at an angle.
Pros:
- a simple method of expanding storage for your keyboards
- sturdy
- easy to assemble.
Cons:
- none, really!
You can also adjust how far forward they extend over your existing keyboard, so you can have the upper one further back, to allow easier access to any surface controls.
The ends have a rubber-capped stopper, so your keyboard won't slip off if you have it tipping down at an angle.
Pros:
- a simple method of expanding storage for your keyboards
- sturdy
- easy to assemble.
Cons:
- none, really!
3
1
Report
A
Sturdy Stacker
Very sturdy stacker, works perfectly in combination with the stand.
I've used it for small, medium and bigger instruments (MS101, OB-6 and a Hammond xk1c) and it worked perfectly for all of them.
Very high quality as you can expect from K&M.
I've used it for small, medium and bigger instruments (MS101, OB-6 and a Hammond xk1c) and it worked perfectly for all of them.
Very high quality as you can expect from K&M.
1
0
Report
AF
Great Quality as Always from K&M
Very good quality. The price might be higher than with budget competitors, but the stability and built quality is supers. I would rather trust these holders to hold my keyboard.
1
0
Report
M
Easy to Set Up, Solid!
Incredibly fast to install I am constantly changing my studio set-up and use these with an 18950. My only wish i that a third tier was available for this set-up. Other than that, a great solid product! Cheers Mike
I bought another set for the studio stand to go three tiers. I realise that they are not designed for this use, and the top keyboard sits a little far back, but if I am careful it works and I am happy with the setup.
I bought another set for the studio stand to go three tiers. I realise that they are not designed for this use, and the top keyboard sits a little far back, but if I am careful it works and I am happy with the setup.
0
0
Report
N
The 30kg might be an exagerration, but it has been reliable for years now.
The quality of this stacker is noticeably good.
That being said, I only used it for my laptop.
A 20kg Moog One makes it wobble while playing. It doesn't look close to breaking or anything, but I wouldn't trust it with top-end devices, despite them weighing around 2/3 the supposed load capacity.
That being said, I only used it for my laptop.
A 20kg Moog One makes it wobble while playing. It doesn't look close to breaking or anything, but I wouldn't trust it with top-end devices, despite them weighing around 2/3 the supposed load capacity.
0
0
Report
M
Great for what it is.
This is a simple and sturdy stand that does what it’s supposed to.
0
0
Report
I
Quality 2nd tier
I like the quality of this product and found very straight forward to set up - once in place they are very stable and highly adjustable ..... to the point where you could find yourself struggling to get both arms lined up at the same angle when you tilt the arms .... would have been nice to have some indicators sketched onto the brackets to you can use that as a guide - However this is a small point as once set at your preferred angle you can leave them like that and simply stick them in your back along with the 18950 without having to alter :-)
0
0
Report
MG
TOP !!!!!!
Its perfect I love the architecture
0
0
Report
B
Allows me two keyboards on my K&M 18950
The K&M 18950 keyboard stand is really good and the accessories are equally good. With these stackers I can confidently add a 2nd keyboard. Sturdy and robust.
0
0
Report
