Tama RB8P Plastic Bottom

They do what they are supposed to.

But they do wear down after a couple of years.

These sleeves have a very strong build quality which one would expect from Tama but I find them to be way too long. They actually cover up most of the thread on the cymbal arm and leaves no room for a wing nut to screw on.

I have tried these on several cymbal arms and they were too long for every one of them. Of course the solution is to just cut the bottoms of them to make them shorter but one would be a lot happier if the product they had bought would work the way they wanted straight away.

Well, there's not that much to say regarding these cymbal sleeves: they are durable and reliable, that's it.
I used them since forever with my Tama cymbals, and maybe this is one con: these sleeves are not working with all stands, but if you have Tama ones or if you have a thread size that is compatible with this diameter (M8), these sleeves are the right choice.

These are great but my only problem is that they only work on tama harware, I have two mapex cymbal stands which they do not fit on as the tip of the arm/stand is a little too thick.

Great quality product though all the same.

These are good quality cymbal stand accessories! Lasts long!

Be careful. Only for Tama hardware. I bought it for my hardware but it did not work, so it was useless!

Works fine, maybe a bit better and live longer than no-name plastic bottoms, but almost the same.

I purchased this product and have not withheld
After all, the quality of Tama speaks for itself
always pleases quality and an interesting thought-out design
Tama Thanks for this product and store you can buy it all the best

Better than all the others.