EBS EBS DC2-90F Flat Daisy Chain

166

Power Distribution Cable

  • 2 Outputs
  • Input: 1x 2.1 mm Straight hollow connector
  • Outputs: 2x 2.1 mm Angled hollow connector
  • Polarity: Standard (negative)
  • Length: 30 cm
katalógusunkba bekerült: Január 2019
Termékszám 456449
mennyiségi egység 1 darab
2 299 ft
ÁFÁ-val, plusz 6 900 ft szállítási költség
1-2 héten belül szállítható
1-2 héten belül szállítható

A termék hamarosan megérkezik raktárunkba, ezt követően rövid időn belül szállítható.

Szállítással kapcsolatos tájékoztató
1

166 Ügyfelek értékelései

4.8 / 5

A termékek értékeléséhez kérjük, jelentkezz be.

Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.

A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.

kivitelezés

69 Vélemények

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
H
Work ok but the wire to the plugs is weaker than some other brands
HalfManHalfGear 17.07.2020
The profile and size of the jacks is very compact but the wire going into them isn't as secure and resistent as I'd like it to be -and I have had at least one start to separate. I now prefer to use the Rock board ones because despite their jacks being slightly bulkier, the cable connections seem more trust worthy.
kivitelezés
2
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
P
It works great!
Panos! 22.06.2021
When you have more pedals on your pedalboard than your power block can handle, then you need something like this. Just be sure to check, first of all, that the total need of mA from both pedals doesn't exceed the mA output of the power block's port you'll use, and secondary, because the aforementioned pedals will not be isolated from each other, that there is no mains hum from them. So, how many pedals on our pedalboard are too many?
kivitelezés
1
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
_
It does what is designed for
_obra_ 09.02.2021
I connected two 100mA (TC) pedals into one Voodoo Lab 400mA output.
Works with no problems and no hissing.

Update:
The rubber insulation on the joint of wire and the jack broke. You can see the wires inside. There was no pulling of any kind or strong sudden moves.

Lowered the total from 5 to 2 stars.
kivitelezés
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
H
Bit loose
Hihon 30.07.2021
I connected EBS Dc power cable first. they are not tight enough. Now I connect this cable and another brand DC cable, they are tight enough.
kivitelezés
0
0
Jelentem!

Jelentem!