TritonAudio FetHead Phantom

106

Microphone Preamp

  • For condenser microphones
  • Extremely low-noise Class A JFet amplifier
  • XLR 3-pin female to XLR 3-pin male
  • 18 dB gain (@3 kOhm load)
  • 4 Coordinated JFets
  • 48 V Phantom power
  • Transfers phantom power to the microphone
katalógusunkba bekerült: Május 2018
Termékszám 439148
mennyiségi egység 1 darab
Channels 1
Number of microphone inputs 1
Instrument input No
Tubes No
Compressor/Limiter No
Equalizer No
De-Esser No
Phantom power No
Phase Reverse No
External effect loops No
Analogue Outputs XLR
Digitale Outputs 0
Headphone connection No
Level Meter No
Design Adaptor
31 690 ft
ÁFÁ-val, plusz 6 900 ft szállítási költség
Azonnal szállítható
Azonnal szállítható

A termék raktáron van és azonnal szállítható

Szállítással kapcsolatos tájékoztató
Szállítás megközelítőleg Csütörtök, 4.04. és Péntek, 5.04. közt.
1

106 Ügyfelek értékelései

4.6 / 5

A termékek értékeléséhez kérjük, jelentkezz be.

Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.

A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.

kezelés

tulajdonsagok

hangzás

kivitelezés

67 Vélemények

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
z
Perfect for my needs
zorglub76 08.03.2021
First of all, I don't have a producer's ears. So when I say that there's absolutely no noise when using these preamps, take it with a grain of salt.
I have a specific problem that I tried to solve with the FetHead, and I solved it easily. The problem is that I'm getting some digital noise in my Focusrite Scarlett whenever I turn gain passed 1 o'clock. I don't know if it's a psu, or the nearby laptop or something else, but I couldn't get rid of it.
Now, with the FetHeads, I pre-amplify my mic, and I need just a slight gain from Scarlett, so the noise is gone! The sound is exactly the same as without the FetHead, just louder. I hear no distortion or noise. I'm using Lewitt small diaphragm mics that are especially noiseless, but I hope the others would behave the same.
I'd recommend FetHead as a cheap solution to any gain related problems you might have.
kezelés
tulajdonsagok
hangzás
kivitelezés
5
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
M
Amazing
MB202 18.12.2020
For this price you get a a lot of extra gain with no loss of audio quality (somehow, I get only 15Db, but OK). Very useful to pump up any signal. More importantly, it makes your mics sound better as you don't have to crank up the pre (better to find that the "sweet spot"). Highly commendable.
kezelés
tulajdonsagok
hangzás
kivitelezés
4
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
L
Great device that gets the job done
Lonesomeflat 05.07.2022
The preamps on my audio interface and my zoom recorder were a bit too weak for my Rode NT2A. To get sufficient gain I needed to push them to their limits and it produced an awful lot of noise.

The Fethead Phantom is the answer to this problem.
It works really well, no more noise on my recordings and I have more headroom to work with. I'm really more than happy with this product.

I would recommend it to anyone who is in that situation with not enough gain to drive the mic, or just barely enough but getting lots of preamp noise.

Awesome little device !
kezelés
tulajdonsagok
hangzás
kivitelezés
2
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
R
Serves the required purpose for relatively low gain condenser microphone.
Robert8105 19.03.2019
I have a particular condenser microphone that needs a high gain setting on my mixer's preamp, and so has a tendency to cause noise because of the near maximum setting. The FetHead Phantom was the answer because this in-line microphone booster takes its power from the phantom power supplied by the mixer at source and in so doing the FetHead's energised circuits enable about + 18dB further gain to be inserted at the right point. The whole purpose of the device is then achieved because it means the mixer gain rotary switch was advanced to a lesser point than without the FetHead and so noise was eliminated.
The Triton FetHead was cheaper than some rivals and effective for my purposes although no comparisons were made with other makes.
kezelés
tulajdonsagok
hangzás
kivitelezés
8
0
Jelentem!

Jelentem!

YouTube a témában