Yamaha BMS10A

209

Stand-AdapterPassend voor:

  • MS 20
  • S 15
  • MSP 3
  • MS 101 II
  • MS101 III
  • MS 203 II
  • MG 102 C
  • MG 82 CX
  • Stagepass 400i
  • Stagepass 600i
  • MG 06, 06x, 10, 10xu
artikelnummer 106561
verkoopseenheid 1 stuk
Electronic Accessories No
Cabinet Accessories No
Stand a. Flying Stud Accessories Yes
€ 63
Incl. btw plus € 5,90 verzending
In 1-2 weken beschikbaar
In 1-2 weken beschikbaar

Dit product verwachten we binnenkort op voorraad en kan dan direct worden verzonden.

Informatie over de verzending
1

209 Klantenbeoordelingen

4.5 / 5

U moet ingelogd zijn om producten te evalueren.

Note: Om te voorkomen dat evaluaties gebaseerd zijn op roddel, geruchten of heimelijke advertentie staan wij op onze website alleen evaluaties toe van daadwerkelijke gebruikers die het geevalueerde product bij ons gekocht hebben.

Na inloggen vindt u alle producten die u kunt evalueren ook onder “Product evalueren” in uw klantencentrum.

afwerking

95 Recensies

FC
Een vondst!
French Cleaners 31.03.2022
Ik was van plan om zelf een beugel te knutselen. Maar dit is de ideale beugel voor mijn stagepass 400.
Nu heb ik eidelijk de mogelijkheid om onder het spelen het geluid bij te regelen, zonder ingewikkeld gedoe met tafeltjes, barkrukken enzovoort. Past op een stevig microfoon statief en neemt dus nauwelijks plaats in.
afwerking
0
0
Evaluatie melden

Evaluatie melden

w
handig
walterdv 17.11.2018
emx2 op statief gezet hiermee. werkt prima
afwerking
0
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
R
Does the job, very robust, a little finicky
Ruaille 20.01.2019
I got this for the Yamaha MG10XU mixer and it works fine and it is built to last. I used it for pub gigs on a mic stand and the mixer was very secure.

It?s a little bit finicky to attach to the mixer due to the placement of the butterfly heads but once it?s on it?s not going anywhere.
afwerking
2
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
GM
Good but...
Gavin M. 26.10.2015
This is a great unit that works perfectly when set up, but the set up is hardwork and time consuming. I use this bracket for the yamaha stage pass mixing console.

This bracket is great when assembled, you can turn it to a 45 degree angle and easily access volume, treble, reverb etc. I got it so that the singers I work with would have access to their own sound mix. I use it on a short guitar stand and have it the same height as my keyboard.

The downside is the assembly. I have it permanently attached to the guitar stand but the mixing console still has to have the screws inserted into the back of it - this is a tedious process and takes a few minutes. Often I meet singers right before an event and we have very little time to check keys, run through songs. No way do I have time to start playing with tiny screws, lining them up with the unit, misjudging, starting again.

So overall, great unit, but 4 stars only for the assembly design and set up.
afwerking
0
0
Evaluatie melden

Evaluatie melden