EBS EBS DC2-90F Flat Daisy Chain

166

Power Distribution Cable

  • 2 Outputs
  • Input: 1x 2.1 mm Straight hollow connector
  • Outputs: 2x 2.1 mm Angled hollow connector
  • Polarity: Standard (negative)
  • Length: 30 cm
Produkt dostępny od Styczeń 2019
Numer artykułu 456449
Jednostka sprzedaży 1 szt.
23,60 zł
Zawiera podatek VAT, nie zawiera kosztów wysyłki 49 zł
Dostępny za 1-2 tygodnie
Dostępny za 1-2 tygodnie

Produkt będzie za niedługo dostępny i natychmiastowo gotowy do wysyłk.

Informacje dotyczące wysyłki
1

166 Oceny klientów

4.8 / 5

Aby wystawić opinię, należy się zalogować.

Informacja: Aby opinie na temat sprzętu umieszczane na naszej stronie pochodziły jedynie od osób mających styczność z danym artykułem, umożliwiamy wystawianie ocen jedynie naszym klientom.

Opinie można wystawiać po zalogowaniu się w centrum klienta, używając opcji "wystaw opinię".

wykończenie

69 Opinie

GG
Dobrej jakosci przewód
Gregg G 13.02.2023
Solidnie wykonany, dziala bez zarzutu
wykończenie
0
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
H
Work ok but the wire to the plugs is weaker than some other brands
HalfManHalfGear 17.07.2020
The profile and size of the jacks is very compact but the wire going into them isn't as secure and resistent as I'd like it to be -and I have had at least one start to separate. I now prefer to use the Rock board ones because despite their jacks being slightly bulkier, the cable connections seem more trust worthy.
wykończenie
2
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
P
It works great!
Panos! 22.06.2021
When you have more pedals on your pedalboard than your power block can handle, then you need something like this. Just be sure to check, first of all, that the total need of mA from both pedals doesn't exceed the mA output of the power block's port you'll use, and secondary, because the aforementioned pedals will not be isolated from each other, that there is no mains hum from them. So, how many pedals on our pedalboard are too many?
wykończenie
1
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
_
It does what is designed for
_obra_ 09.02.2021
I connected two 100mA (TC) pedals into one Voodoo Lab 400mA output.
Works with no problems and no hissing.

Update:
The rubber insulation on the joint of wire and the jack broke. You can see the wires inside. There was no pulling of any kind or strong sudden moves.

Lowered the total from 5 to 2 stars.
wykończenie
0
0
Zgłoś nadużycie

Zgłoś nadużycie