Millenium DS200 Black

147

Table Microphone Boom Arm

  • Aluminium construction
  • Locking centre joint
  • 5/8" threaded connector
  • Table clamp for up to max. 56 mm table thickness
  • Pre-wired with XLR cable
  • Length of upper arm: 43 cm
  • Length of lower arm: 40 cm
  • Maximum load capacity: 1.5 kg
  • Colour: Black
Produkt dostępny od Wrzesień 2018
Numer artykułu 437359
Jednostka sprzedaży 1 szt.
Type Microphone Boom
Colour Black
Weight 1,8 kg
Pokaż więcej
299 zł
Zawiera podatek VAT, nie zawiera kosztów wysyłki 49 zł
Dostępny w magazynie
Dostępny w magazynie

Produkt jest dostępny w magazynie.

Informacje dotyczące wysyłki
Wysyłka spodziewana do dnia Piątek, 19.04.
1

147 Oceny klientów

4.2 / 5

Aby wystawić opinię, należy się zalogować.

Informacja: Aby opinie na temat sprzętu umieszczane na naszej stronie pochodziły jedynie od osób mających styczność z danym artykułem, umożliwiamy wystawianie ocen jedynie naszym klientom.

Opinie można wystawiać po zalogowaniu się w centrum klienta, używając opcji "wystaw opinię".

stabilność

wykończenie

96 Opinie

google translate gb
Wystąpił błąd. Proszę spróbować później.
P
not bad but room for improvement
PKristoffersson 13.02.2020
I bought this table microphone stand so I could do work either sitting or standing by my desk, depending on whether I would be singing or speaking.

This stand supports my microphone (a t-bone 400) with no issue and the reach is long. However, adjusting it is a bit of a pain. There are three separate joints that need to be tightened. The joint closest to the microphone is rather limited in its range of motion. Also, since all joints are hinge type joints it's not easy adjusting to get the microphone exactly where you want it. Overall it's something one can work around, it just takes time.
2
1
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
S
had this for about 1 year
SixStackJack 06.01.2022
bought this one coas i needed a somewhat cheap boom arm for my AT2020 mic, and it works great, the arm keeps still and its somewhat easy to adjust it to your needs,
i had some problems getting the part where you fasten it to the table to stay in place, so i ended up drilling two holes from the top of the "plate" into the table, and then screw it in :D. now it wont move eaven if there was an earthquake :;D
wykończenie
stabilność
0
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
M
Solid sturdy build quality, no fiddly wiring or cable tidy to deal with.
Melodyguy 22.03.2022
Needs a good stiff tightening to your studio table. So easy to move about and push mike off side out of use. Really like the black finish, blends well with other equipment.
wykończenie
stabilność
0
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
S
Saucemountain 26.01.2022
Very nice microphone arm, but the clamp is pretty weak and a bit to small for my table. The clamp can't get a good enough grip on the table which means that it can move about a little bit sometimes. Not the biggest issue but worth mentioning.
wykończenie
stabilność
1
0
Zgłoś nadużycie

Zgłoś nadużycie