the box Replacement Speaker MBA120W

2

Replacement Speaker

  • For MBA120W and MBA120W MKII
  • Size: 10"
  • Impedance: 4 Ohm
Produkt dostępny od Maj 2016
Numer artykułu 389134
Jednostka sprzedaży 1 szt.
Impedance 4 Ohms
Load Capacity 120 W
279 zł
Zawiera podatek VAT, nie zawiera kosztów wysyłki 49 zł
Dostępny w magazynie
Dostępny w magazynie

Produkt jest dostępny w magazynie.

Informacje dotyczące wysyłki
Wysyłka spodziewana do dnia Czwartek, 25.04.
1

2 Oceny klientów

4.5 / 5

Aby wystawić opinię, należy się zalogować.

Informacja: Aby opinie na temat sprzętu umieszczane na naszej stronie pochodziły jedynie od osób mających styczność z danym artykułem, umożliwiamy wystawianie ocen jedynie naszym klientom.

Opinie można wystawiać po zalogowaniu się w centrum klienta, używając opcji "wystaw opinię".

dźwięk

wykończenie

2 Opinie

google translate gb
Wystąpił błąd. Proszę spróbować później.
PR
10" 4-ohm speaker.
Peter R. 438 06.07.2016
I got this to replace a suspect 4-ohm co-axial speaker/horn in an acoustic combo.

The original speaker was 10" too, but was a bit "grindy/mushy" above 1/2 volume, I suspected the horn for this problem after wiring into a PA speaker instead.

I fitted the new speaker & got another 1/4 turn on the volume before the "grindy/mushy" problem reappears. There is some AC smoothing problems on the amplifier circuit board, but I can use almost full volume now & the extra db (sound) this speaker punches out is great. The lack of a horn helps smooth the sound too.

This speaker comes on song, sounding good at 100 hz and holds a good sound till around 3 - 4 Khz, 5 - 10khz is only for dogs and cats to hear. The new speaker is a little bigger in physical size & weight than my original 10" speaker, mounting holes are the same though.
Well worth the work for its stronger & cleaner sound.
dźwięk
wykończenie
0
2
Zgłoś nadużycie

Zgłoś nadużycie

google translate de
Wystąpił błąd. Proszę spróbować później.
A
Anonimowy 03.08.2016
Dieser Speaker wurde von mir als Ersatz eines defekten
Lautsprechers in einer aktiven "Plastik-Box" eingesetzt.
Meine Auswahlkriterien waren: mechanisch sollte er passen, relativ leicht sein, guter Wirkungsgrad und 4 Ohm.
Aus der Artikelbeschreibung ging schon viel hervor, dass der Wirkungsgrad ordentlich sein wird erhoffte ich mir, da dieser ja für eine Akkubox vorgesehen war, wo mit relativ niedriger Verstärkerleistung gearbeitet wird.
Alle meine Erwartungen wurden erfüllt. Übrigens ist es ein italienisches Produkt, welches einen sehr soliden Eindruck macht.
dźwięk
wykończenie
2
0
Zgłoś nadużycie

Zgłoś nadużycie