B
Esential tuner for beginner eurorack
I was debating shelling out for the Mordax DATA but there is nothing this little guy doesnt do for half the foot print that id use the DATA for.
1
0
Zgłoś nadużycie
m
Excellent easy to use scope
Very easy to use scope, controls are intuitive and integration within patches makes it easy. The V range is nice, I have a full-size scope near the rack that cost four times as much and most of the time end up just using this scope since it is designed _for_ eurorack voltages. Size is a benefit for smaller setups, but does come with the compromise of the smaller screen, but that should be expected. My only issue was the top M3 screws have a longer thread and thus cannot be replaced with knurlies and thus is the one module that requires a screwdriver. However, if installed in the right place (as it is in my setup) one should not need to worry about this after install.
0
0
Zgłoś nadużycie
B
All is clarity
You can see what it does just by looking at it, and what it does it does as well as might be expected, given the tiny, monochrome, OLED. It is a shame that the sample-timing steps are so few and far between – as a result of which you're going to have to tune your sine waves to accommodate the machine if you're hoping to raise any stimulating Lissajous patterns from its XY mode – But stimulate they do. And it turns out that having an oscilloscope within easy reach at all times is even more useful than I'd anticipated. Had this thing on the 40U travelling essentials rack within minutes, right next to the ES-8, and I imagine it'll stay there for quite some time.
0
0
Zgłoś nadużycie
x
Nice 2 channel oscilloscope
Only downside is, that the display is rather small, but then it fits in 6HP.
I can highly recommend having an oscilloscope in your modular rack, especially for looking at complex control voltages, for example a mix of LFOs.
I can highly recommend having an oscilloscope in your modular rack, especially for looking at complex control voltages, for example a mix of LFOs.
0
0
Zgłoś nadużycie
BS
Works Great
No problems with this module, the ZeroScope is easy to use.
0
0
Zgłoś nadużycie
Rt
Useful, but a bit fiddly
It’s very useful to have an oscilloscope in the system, and at 6hp this is ideal. It has a good range, but the menus are a bit fiddly, and the ‘bolt-on’ screen protector makes it tricky to move around the rack.
0
0
Zgłoś nadużycie
TR
The most useful device in my rack
Being able to see the wave for a signal chain is invaluable. It makes it easier to understand what other modules are actually doing. The unit has two inputs that lets you monitor two signal chains.
0
0
Zgłoś nadużycie
