K&M 15222 Clarinet Stand

412

Clarinet Stand

  • 4 Leg base for optimum stability
  • While transporting the lower part can be pushed into the cone and stored in the bell of the clarinet
  • Black plastic peg
  • Fits most clarinet models
  • Colour: Black
  • Weight: 0.1 kg
  • Height: 180 mm
  • Fits most clarinet cases
disponibil din Martie 2001
numărul articolului 147240
unitate de vânzare 1 bucată(ăţi)
66 lei
Include TVA la care se adaugă 89 lei costul de transport
în stoc
în stoc

Acest produs e disponibil în stoc și poate fi expediat imediat.

Informații despre livrare
Livrare aprox. între Luni, 22.04. și Marţi, 23.04.
1

412 Evaluările clienților

4.8 / 5

Pentru a evalua produse trebuie să fiţi logat.

Reţineţi: Pentru a preveni evaluările bazate pe zvonuri sau reclame ascunse permitem doar evaluări de lşa clienţii noştri reali, şi care au cumpărat echipamente de la noi.

După logare veţi găsi de asemenea toate articolele care pot fi evaluate Centrul Logare Clienţi.

Stabilitate

Manipulare

Măiestrie

172 Recenzii

C
Very OK
Clipmania 27.06.2022
it`s small but ok , its what i need .
Stabilitate
Măiestrie
Manipulare
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
A
A really good clarinet stand
Anonim 05.03.2015
I've bought a few of these - they don't wear out, I just have more than one clarinet. They're very stable, because of the four legs, and the fact that they put the clarinet bell very low to the floor.

They fold up easily, and are small and light to take with you. You could store it in the bell of your clarinet, in the case, if it's a Bb, though I'd probably want to put a thin cloth between them, or pack something under it, like cotton wool, so it couldn't move.

I'm using these stands for a Bb, two Cs and a small Eb clarinet. The bell of the Bb swallows the curved base of the stand, the Cs just about cover it, and the Eb sits on it, with a bit showing around the bell. They all fit it well, though.
Stabilitate
Măiestrie
Manipulare
2
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
A
Feels flimsy, but surprisingly sturdy
Anonim 02.01.2017
The stand legs look very thin when deployed, particularly at the connection to the portion which sits inside the bell. However they are metal, not plastic, and therefore unlikely to snap. The legs fold up on a screw-in base, then slot in to the hollow bell portion, which then stores in the clarinet bell; the bell is then completely filled by the stand when in the clarinet case, so you will want to clean/dry the bell before storing.
It takes less than 15 seconds to put the stand up and down.
This is an ideal stand for orchestral/ band players as it is small enough to sit by a chair without looking obtrusive. It is very stable for this use.
If on a stage where people might bump into it, I'd probably want something with a bit more stability (but therefore bigger and not able to store in the bell!).
Stabilitate
Măiestrie
Manipulare
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
EH
Good stand, not perfect though.
Emma H. 10.04.2014
I purchased this as a replacement for a previous version that was lost. First thing, it does fit in the bell of the clarinet, however is a bit too big to just stay in the bell, so it does protude slightly into the bottom joint. This is fine if you have a BAM case or similar as there is lots of room. I doubt if you were using a small case eg a Yamaha single case it would fit.
I have found that it is not as stable as my previous one, and it can be quite easy to knock it over. Having said that, take good care and you will be fine!
Stabilitate
Măiestrie
Manipulare
1
0
semnaleaza un abuz

semnaleaza un abuz