Radial Engineering Tonebone Bigshot ABY/Y MKII

63 Evaluările clienților

4.7 / 5

Pentru a evalua produse trebuie să fiţi logat.

Reţineţi: Pentru a preveni evaluările bazate pe zvonuri sau reclame ascunse permitem doar evaluări de lşa clienţii noştri reali, şi care au cumpărat echipamente de la noi.

După logare veţi găsi de asemenea toate articolele care pot fi evaluate Centrul Logare Clienţi.

Caracteristici

Măiestrie

37 Recenzii

Radial Engineering Tonebone Bigshot ABY/Y MKII
777 lei
Include TVA la care se adaugă 89 lei costul de transport
Disponibil in 2-3 Saptamani
Disponibil in 2-3 Saptamani

Asteptam acest produs in stoc curand si va putea fi expediat imediat.

Informații despre livrare
1
google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
S
Nice ABY
Seungku 16.04.2018
I needed to run two amps at the same time, while I was recording. So, I was in hunt of nice ABY switch and this came up.

Pro: It has every features proper ABY switch should have. Built like tank, has enough LEDs so you know where your signal goes. On output [B], ground lift and isolation transformer to eliminate ground hums and buzz, can reverse polarity to prevent phase problem between two amps. Very effective and thoughtful.

Con: There's noticeable tone shifting when you engage 'Isolation transformer' on. So you had to tweak amp's knobs on output B again to get the sound you like.

If you are looking for proper ABY switch, look no further. Get this. I am giving just 4 stars because after recording, I hardly use it in actual gig or practice situations.
Caracteristici
Măiestrie
1
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
K
Great piece of gear!!
Katito 04.07.2017
Used to have problems with ground loops while playing in stereo, the noise was just unbearable. Since I purchased this well constructed metal chassis pedal everything works as it should, not to mention that both amps work in fase now. It's smaller than it seemed in the photos which is nice to save space in the pedal board. No power needed unless you want to know where you're at, and in that case the LEDs let you know if you're playing A, B or both amps. Probably the most robust pedal I have, I'm very happy with it! Highly recommended if you play in stereo!
Caracteristici
Măiestrie
1
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
KA
KIKI ARIKI 06.07.2020
So far this meets my expectations well. Have used it to send one signal to an amp with solid state preamp/ tube power amp, and the other signal going to DAW via a USBinterface. Very quiet. Also worth mentioning I used an isolated power supply. When tried with 2 Amps, the previously mentioned one and a Blackstar id core 40 v2, ground lift helped to remove some noise. However there was some higher pitched noise from the Blackstar. I suspect it is something to do with the digital amp circuitry. I am yet to try the device with two completely non digital amps. With both setup scenarios I did not notice any tone loss.
Caracteristici
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
F
Solid and works!
Frednugent 29.05.2019
I love Raidial gear. Just found out about them and this is my 2nd piece in the last few months. Like the JDI this piece just does what it should in a really solid and clear way. Split your signal to A or B or have both playing. I just tried with vocals through 2 little amps for a live show and it worked perfectly. Its passive so you dont need power (unless you want the LED). It's a bit on the heavy side but still small. I can tell it's going to last for years. Solid, easy, small = Great.
Caracteristici
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
d
perfect!
didierleclair 06.12.2017
I use this for a wet/dry setup.

pro:
isolation is key
gnd lift and phase switch

con
none

easy to use 10/10
Caracteristici
Măiestrie
1
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
J
Using two amps have never been easier
Jrgn 09.02.2021
This thing works as it should, with no hum or noise when using two amps together.
Caracteristici
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
Bw
Works as intended
Bedroom warrior 08.03.2020
Not sure what to review on this. It works as intended, and it helped get rid of some ground loop hum. Great bang for your buck.
Caracteristici
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
M
MVDSN 09.12.2019
I use this to split my signal to a dry and a wet amplifier, so the ground lift and isolation switches are necessary to avoid ground loops and unwanted hum in either amplifier.
Costs a bit more than other alternatives, but the build quality and added switches make it more than worth it.

+) Build quality. I don't expect this to give up on me anytime soon.
+) Great added features to a simple ABY concept. (tuner out, ground lift, isolation and phase swap)
-) Higher price. But justified by great features and reliability.
Caracteristici
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
m
meelo 16.04.2019
I needed an ABY switch and juggled between this and the cheap Fender ABY switch. Somehow I decided to buy the one that was three times more expensive, just because the switch is more than likely to never break.

Didn't know why I would ever need a ground lift or isolation feature, but it definitely came in handy when I bought a second amp and plugged that into the pedal system. Massive amount of interference and fuzz kicked in, but with a push of a button, all noise disappeared!
Caracteristici
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
D
Danobat 30.11.2018
Great tool if you use two amps. Compact size, sturdy construction, and it needs power just to lit the LEDs! The only thing I don't understand is why the ISO mode (which enables polarity inversion and ground/lift) is switchable.. to me it would make sense to have it always on. But it's just a small detail.
Caracteristici
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

Radial Engineering Tonebone Bigshot ABY/Y MKII