Artec SE-2A Bass Electronic Set

108

Starta 360°

Visa översättning

Bass Electronics

With 2-band EQ on tandem knobs
To connect to active or passive pickups
3 Knobs for treble - bass and tandem (volume)
Bass: +/- 12 dB @ 100 Hz
Treble: +/- 12 dB @ 4 kHz
Matching potentiometer knobs: art. 339884 and art. 339886 (not included)

30 30 dagar öppet köp

Tillgänglig sedan Augusti 2004

Artikelnummer 172727

försäljningsenhet 1 Styck

Equalizer 2-Band

279 kr

inklusive moms, 99 kr frakt tillkommer

Leverans beräknas mellan Onsdag, 24.04. och Torsdag, 25.04.

Säljranking

i Elektronik för Elbas

Detta är vad kunder som tittade på denna produkt köpte

Artec SE-3 Bass Electronics Set

222 kr

köpt

Glockenklang 2-Band Electronic

1 469 kr

köpt

Darkglass Tone Capsule Bass Preamp

1 990 kr

108 Kundbetyg

5 47 Kunder 4 34 Kunder 3 18 Kunder 2 7 Kunder 1 2 Kunder

4.1 / 5

ljud

hantverkskvalitet

Poängpolicy

75 Recensioner

For the money, excellent

Bribedant 27.04.2021

Has not very much experience of bass preamp's but this one mounted in my Washburn Status bass (old preamp died) does a better job than I expected. One warning, pots with circuit board are high, about 33mm inside cave. I had to 3D print an new cavity lid. Can't tell about build quality. Everything works fine as new tho.

Anmäl recension

Uppfattar du det som att denna recension använder felaktiga fakta eller som stötande av någon anledning? Vänligen skriv en notis och gärna din e-postadress i textfältet.

Visa översättning

Visa original

Tyvärr uppstod ett fel. försök igen senare.

Preamp good but watch the wiring

Woodinblack 17.01.2018

I fitted this on a previously passive Iceman bass. The shafts of the pots aren't long, so I had to do a bit of woodwork and the width of the dual concentric tone control is bigger than a normal tone knob, so the hole needed to be rewired. They give you a good amount of cable to position the battery.

I had a problem in that after grounding the bass, it no longer made any noise and found out that the wires that went from the balance output to the tone input were reversed which was shorting out the board. Taking the pins out of the plug and putting them in correctly (as the silk screen on the board shows) fixes the problem. Also note that there are no instructions with these preamps, although instructions are on artecs website. Everything is wired (even if incorrectly) apart from battery +/- and jack out/ground/switch solder terminals on the board.

Apart from the wiring issue, which is why I marked quality down, the actual quality of the preamp is fine, I can hear no difference with it in or out of the circuit with the tone controls flat, as it should be, and the tone controls provide a useful range of options.

Anmäl recension

Uppfattar du det som att denna recension använder felaktiga fakta eller som stötande av någon anledning? Vänligen skriv en notis och gärna din e-postadress i textfältet.

Visa översättning

Visa original

Tyvärr uppstod ett fel. försök igen senare.

Good upgrade!

Cesar593 13.10.2017

This is a noise free, reliable and very well built active preamp for bass guitar! I have used it to replace a noisy preamp in an older bass, and I am very satisfied! Not only did the noise disapear, but it now sounds louder and deeper. Don't be fooled by the price, this is a great preamp! Best for the buck out there, no doubt about it!

Anmäl recension

Uppfattar du det som att denna recension använder felaktiga fakta eller som stötande av någon anledning? Vänligen skriv en notis och gärna din e-postadress i textfältet.

Visa översättning

Visa original

Tyvärr uppstod ett fel. försök igen senare.

Transparent when you work out why it's flawed

Sethguitarman 10.12.2022

So initially I thought this preamp sucked the tone massively from my musicman style pickup, making it quite boxy / dead. Then I realised that at centre detent the EQ is actually sucking half the bass and treble out of the mix. When both hi/low are at 100% my pickup was back to sounding as it should (with a nice quiet transparent boost). So really you need to leave it at 100% and the roll back the bass for a treble boost, and roll back the treble for a low pass. A proper designed preamp should be effectively bypassed at the middle position, this is not. hence the three stars.

However when you know this it can be used quite effectively, if you're good at soldering the stacked potentiometer can be replaced with two seperate hi & low pots. The volume control is very smooth and linear which is great.

Anmäl recension

Uppfattar du det som att denna recension använder felaktiga fakta eller som stötande av någon anledning? Vänligen skriv en notis och gärna din e-postadress i textfältet.

Läs alla recensioner

Artec SE-2A Bass Electronic Set

Bass Electronics

Detta är vad kunder som tittade på denna produkt köpte

108 Kundbetyg

Du måste vara inloggad för att kunna betygsätta en produkt.

75 Recensioner

Smart Navigator

Nyligen visade produkter

Handla och betala säkert

Dina fördelar

Service

Serveras med kärlek!

Artec SE-2A Bass Electronic Set

Bass Electronics

Detta är vad kunder som tittade på denna produkt köpte

Tillbehör & matchande produkter

108 Kundbetyg

Du måste vara inloggad för att kunna betygsätta en produkt.

75 Recensioner

Jämför alternativ

Smart Navigator