the t.amp E4-130

Har letat efter ett lämpligt flerkanalsslutsteg till rätt pris att använda på mindre installationer av ex bakgrundsljud.
Steget är kraftigt nog att driva 2 högtalare per kanal
E4-130 har förhållandevis lågt brus, och då det är utrustat med jordlyft blir det enklare att hantera jordbrum.
Det finns omkopplare för att linka signal mellan kanal 1-2 och mellan 3-4, vilket är praktiskt. Jag hade dock gärna önskat möjlighet att få ut en ingångskanal till samtliga utgångar.
En nackdel är vikten, det är hyfsat tungt för effekten, men ska det ändå bara sitta fast installerat spelar förstås det mindre roll.
En annan nackdel är att det endast är speakon ut, just som slutsteg för installation så önskar man ju gärna skruvanslutning.

Sammanfattningsvis så är det ett slutsteg med mycket "pang för pengarna" i mindre sammanhang. Vi kommer troligen att fortsättningsvis använda detta slutsteg i våra kommande installationer.

tl;dr : The speaker output wiring is a bit quirky. Lots of gain, possibly not good for sensitive speakers in a smaller room.

I bought this amplifier to have a single amplifier unit to drive a bi-amped passive 2-way speaker setup. The amplifier was driven by a dbx DriveRack PA² (EQ, crossover, driver alignment delay). The only drawback in this application was excessive amplifier gain for the little Black Pearls, since this particular audio setup was not to be played loud. However, another pair of speakers (Radiotehnika S-400 4-way monsters) were perfect to be driven by this amp with both amplifier pairs in bridge mode.

The blowers are audible in a quiet room, but then again, this amp is most likely intended to make the speakers loud before the fans really spin up. Another nice thing is that the automagic stand-by function can be switched off.

It's heavy, too. The case design is such that the amp can be set down on an even hard surface on any of its sides without damage to controls or connectors. Gain controls feel good with a little dampening and have detents.

ATTENTION! Since the observation below is not documented in the manuals, please check the output wiring of your amp before connecting any speakers with any methods not described in the manual! There may be changes between board revisions as products are improved!

So far the only inconsistency between the user manual and the actual device I got is the speaker output connectors. The pairs in them are not connected in parallel as the manual loosely suggests, but are connected so that the second pair (2+, 2-) on ch 1 output matches the first pair (1+, 1-) of ch 2 output. The second pair of ch 2 is left open. (This is actually what I was initially expecting this kind of amp to have!)

This means that you don't need a silly Y-cable for connecting a speaker to a bridged amp as specified in the manual, but connecting the 1+ and 2+ contacts of an odd-numbered speaker output to the speaker's + and - does the trick. Also bi-amping a speaker with dual inputs is easy with just one NL4 SpeakON plug carrying both pairs out of the amplifier.

The same applies to the 3-4 channel pair with the exception that on the ch 3 output connector 2- is connected to 2+ instead of the ground with the other 1- and 2- contacts. This means that both grounds (or "negatives") for bi-amping on ch 3 need to be connected together to 1- instead.

The performance for such a low price tag is great, but you can expect some little quirks like this to come with it.