Bugera PS1 Power Soak

307

Power Attenuator

  • Passive
  • Input: Maximum 100W
  • 3 Inputs with different impedances (4, 8 and 16 ohms), thus usable with almost all amps
  • Speaker output
  • Emulated XLR microphone output
  • Line output with volume control
disponibil din Iunie 2017
numărul articolului 410834
unitate de vânzare 1 bucată(ăţi)
Impedance 4, 8, 16
Noise Supression No
DI Interface Yes
Speaker Simulation Yes
Dummy Load (usable without cabinet) No
B-Stock disponibil 472 lei din
555 lei
Include TVA la care se adaugă 89 lei costul de transport
Disponibil in 2-3 Saptamani
Disponibil in 2-3 Saptamani

Asteptam acest produs in stoc curand si va putea fi expediat imediat.

Informații despre livrare
1

307 Evaluările clienților

4.4 / 5

Pentru a evalua produse trebuie să fiţi logat.

Reţineţi: Pentru a preveni evaluările bazate pe zvonuri sau reclame ascunse permitem doar evaluări de lşa clienţii noştri reali, şi care au cumpărat echipamente de la noi.

După logare veţi găsi de asemenea toate articolele care pot fi evaluate Centrul Logare Clienţi.

Caracteristici

Sunet

Măiestrie

216 Recenzii

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
j
Better than more expensive option
johan75 19.02.2019
I've tested 3 attenuator:
Bugera PS 1 at ¤79
Jettenuator at ¤128
SPL Reducer at ¤369
The SPL and Jettanuator use fancy aluminium housed resistors, the Bugera has plain ceramic resistor that sit elevator from the pcb for cooling.
All 3 devices have just resistors inside, I was expecting some additional components in SPL to justify the price, but only the housing is nicer, the electronics are not.
The SPL has a noisy and cracking potentiometer, the other 2 are noiseless when adjusting the damping level.
The Bugera has an extra feature in the dail that consists of a magnet, a metal plate and an unknown wired component. I'm not sure what this is for, but I think it's to stabilize the resistance of the potentiometer. The more expensive Jettenuator has the same potentiometer but without these extra components.
I didn't have the SPL available for a side by side test, so I only tested the Bugera and the Jettenuator side by side. They sound almost exactly the same, the Bugera is slightly smoother and the Jettanuator sounds slightly more brittle. To me, the Bugera is the more realisticly sounding device.
On both you lose some depth in the sound. Although I find the sound surprisingly good.
Even if all were the same price, the Bugera would be a clear winner for me. The SPL is very disappointing at that price level.
Caracteristici
Sunet
Măiestrie
36
1
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
r
Not too shabby
riffsnoleads 17.03.2021
Works pretty great but I would never hook up a 100 watt head to it. 65 watts would probably be the highest I would go.

As others have said, the more you attenuate the signal the more highs you lose but I have not noticed it to be all that bad personally. If there was any top end loss I made it up with the amp EQ easily.

I found the best aspect is that it can be used as a load box just note that if you do so you have to crank the big knob up to 0 (or no attenuation) and then the Line Level knob will begin to work. You can do this without a cab and it is fine.

Used this to DI a couple of amps I have into a cab IR in my DAW and sounded great.

Gets pretty warm after long use but nothing that will burn you.

Mine made a rather fishy smell (burn in) for the first day or two of heavy use. Stopped after that, just keep that in mind.
Caracteristici
Sunet
Măiestrie
8
2
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
d
deusem 24.02.2020
It's really good at this price range. What I have noticed is that it increases a little bit the gain/distortion compared when it's not connected, but not the bass/mid/treble, so i back down the gain a little bit to have the exact same sound. The manual is not very clear for all the options.
Once it is connected the amp is at half power. Meaning for a 50w amp, the maximum rating will be 25watts.
The power soak knob, is what controls the output, which means that if you use the line out, which is the second knob, you still need volume coming out. That was unclear to me as I thought I could do a "silent recording" with no sound coming from my speaker whatsoever. It is useful however if you don't have a microphone and want to record or sent at a PA at the same time.
Overall it is a great product, small, light, that doesn't need an extra outlet being passive that can tame down a large amp (up till 100w) head and enjoy it in an apartment.
Caracteristici
Sunet
Măiestrie
8
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
A
Tames my Marshall 50W tube amp
Anonim 28.04.2023
I bought a lovely 4x12 cab and vintage Head amp. I just couldn’t turn it up past 2 in my house without the windows rattling.

This solves that problem allowing me to get those tubes glowing at volume 6 /7. It’s sounds amazing!

It does get very hot it you use maximum reduction, but that’s just because of the power it has to dissipate to work.

Highly recommended.
Caracteristici
Sunet
Măiestrie
1
0
semnaleaza un abuz

semnaleaza un abuz

YouTube pe acerst subiect