Millenium Guitar Clothes Rail Hanger

22

Guitar Holder

  • For hanging guitars and basses on clothes rails
  • Suitable for all standard headstocks
  • Total length: 310 mm
  • Depth: 100 mm
  • Width: 82 mm
  • Maximum neck width: 50 mm

Note: not suitable for guitars with nitro lacquer.

disponibil din Iunie 2020
numărul articolului 489622
unitate de vânzare 1 bucată(ăţi)
Material Steel
Type Hang
Suitable For: Acoustic Guitar, Electric Bass, Electric Guitar
For Guitars With Pyroxylin Varnish No
34 lei
Include TVA la care se adaugă 89 lei costul de transport
în stoc
în stoc

Acest produs e disponibil în stoc și poate fi expediat imediat.

Informații despre livrare
Expediere preconizată până Luni, 29.04.
1

22 Evaluările clienților

4.9 / 5

Pentru a evalua produse trebuie să fiţi logat.

Reţineţi: Pentru a preveni evaluările bazate pe zvonuri sau reclame ascunse permitem doar evaluări de lşa clienţii noştri reali, şi care au cumpărat echipamente de la noi.

După logare veţi găsi de asemenea toate articolele care pot fi evaluate Centrul Logare Clienţi.

Stabilitate

Măiestrie

20 Recenzii

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
K
Saved my wall!
Kamui 28.04.2021
I hung it on iron bars I have as room separators.
Work very well. I purchased 22, and am very satisfied.

The hook is wide enough to hang from most sizes of bars, so I can't imagine there being any sort of an issue in that regard.
Further, if you wish, it could also work as a great installation if you fixate a hook onto the roof, and but this hanger on it. The guitars would float above, would look great.

10/10 recommend.
It is also much cheaper here than on Amazon.
Măiestrie
Stabilitate
1
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
m
Perfect for me!
mnoach 23.09.2023
I have "a lot" of string instruments, so I needed a solution to hang them, no free wall available. I thought of a mobile "wardrobe" and self-made hangers, a piece of hardwood with a hole for the rail, and a pair of pins (steel with rubber coating) that would fit into a few holes in that little plank. Cheap, but quite some work, even in my fully equipped workshop. I saw these Millenium hangers and ordered 20 of them, enough for the 2.5m long rail. They are great, even though I might shorten a few to gain space below the instruments, where I will store my pedals (a few dozen). I will check the diameter of the steel wire used for the hangers, and, if possible, I will cut one, make it a bit shorter and thread it, after which I will rejoin both parts with a junction nut. Note that I still have to make the rail stand, a 250x45cm board on 5 wheels (one in the middle, given the length), an edge profile formed from hardwood, two 145cm high aluminium profiles and 2.5m galvanised plumbing pipe (3/4") should do the trick. Some triangular foot pieces and black paint (epoxy for the pipe and profiles) should finish the job.
Măiestrie
Stabilitate
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
SL
Bolji od svog jeftinijeg brata
Sive Lubanje Silom 08.02.2022
Zanimljiva ideja. Baš ono što mi je trebalo za sobu gdje ne smijem bušiti, a imam dosta mjesta za objesiti bas. Ide na dosta toga i može se podesiti. Nisam naišao na slične proizvode u hrvatskim dućanima. Bravo Thomanne!
Măiestrie
Stabilitate
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
A
Works Suprisingly Well
Anonim 18.10.2023
I bought it to hang my bass within my wardrobe, I was not expecting it to work as well as it does, but it was cheap enough to try.
I am glad to say that it is very stable and it is a great value for the money.
Măiestrie
Stabilitate
0
0
semnaleaza un abuz

semnaleaza un abuz