Thon 20U Studio Rack Strip Set

18

Racks Rail Set

  • For self-assembly in Thon studio rack 20U 50
  • 2 Rack rails stocked with nuts and rubber inserts
  • Incl. mounting screws and M6x12 rack screws and suitable washers
disponibil din Martie 2016
numărul articolului 382627
unitate de vânzare 1 bucată(ăţi)
154 lei
Include TVA la care se adaugă 89 lei costul de transport
în stoc
în stoc

Acest produs e disponibil în stoc și poate fi expediat imediat.

Informații despre livrare
Expediere preconizată până Luni, 29.04.
1

18 Evaluările clienților

4.6 / 5

Pentru a evalua produse trebuie să fiţi logat.

Reţineţi: Pentru a preveni evaluările bazate pe zvonuri sau reclame ascunse permitem doar evaluări de lşa clienţii noştri reali, şi care au cumpărat echipamente de la noi.

După logare veţi găsi de asemenea toate articolele care pot fi evaluate Centrul Logare Clienţi.

Măiestrie

9 Recenzii

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
RK
Not compatable
R.L. Kok 15.02.2023
I bought this for my Thon Studio Rack 20U. It was said by an employee that it should be compatable. It's not; it doesn't fit as it should. With that I mean it should start at the bottom and that's where the problem is. It doesn't start there, but at least 1cm above. Besides that it's not so nice to see, it also doesn't have the support from the bottom plate, which is necessary, if the rack is full.
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
A
Additional Rack Strip
Anonim 24.08.2016
So I decided to rack mount as much of my gear as I could with the aim of making my music room as neat as possible an minimising the amount of "trip hazard" on the floor as my long suffering wife has the ability to trip up on her own shadow :)

I wanted to fit a few Adam Hall 87556 sliding rails to the excellent Thon 20U Studio I was purchasing. The sliding rails need mounting at the rear as well as the front so this rack strip was purchased.

After carefully measuring the required front-rear distance my sliding rails required I marked the rack itself, made some pilot holes and fitted the strip with the screws provided.

The fitted nuts make mounting equipment at the space you want (rather than the rack forcing you to use specific spacing) is excellent. I normally use a small Philips screwdriver.
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz