Doepfer A-100Ad5

28

5V Low-cost adapter

  • Plug adapter for +5 V / 100 mA
  • Can be used in place of a 5 V power supply
  • For Doepfer modules requiring +5 V: e.g. the A-113,190 or 191
  • Can be plugged into a free socket on the bus board
  • The current is taken from the 12 V supply
Tillgänglig sedan Januari 2004
Artikelnummer 166503
försäljningsenhet 1 Styck
Description Electronic Component
177 kr
inklusive moms, 99 kr frakt tillkommer
i lager
i lager

Produkten finns i lager och kan levereras omgående.

Information om leveransen
Leverans beräknas mellan Måndag, 6.05. och Tisdag, 7.05.
1

28 Kundbetyg

4.8 / 5

Du måste vara inloggad för att kunna betygsätta en produkt.

Obs! För att undvika att betygsättningen är byggt på rykten eller smygreklam kan bara kunder som har köpt produkten från oss sätta sitt betyg.

Efter inloggningen i kundcentret kan du se vilka produkter som kan betygsättas.

hantverkskvalitet

15 Recensioner

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
S
May the force be with you... exactly 5 volts.
Stephen662 15.07.2013
Needed this to supply 5 volts to some of the modules in my Doepfer case. Yes, some modules (usually logic modules) need 5v to work, and this is what you need.

Simply plugs into the rail that you need to supply the 5v on - if you have 5v modules all over your rack you will need to instal one on each rail as required. Job done. Works a treat.
3
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
A
You might not think you need this but you probably will
Anonym 20.01.2016
This little adaptor will allow you to run anything which requires a +5v power supply on one power rail of your modular case. I bought it because it was required for an oscillator which I purchased, but it can have many applications. My next use for it will be to power LED lights to illuminate my modular in gig situations. You simply connect the adaptor to a spare connector on the rail which you will need it, and then you have +5v power available for all the other connectors on that rail. My one reservation is that this could have been a little bit cheaper for what it does, or alternatively Doepfer could just build this provision into their modular cases as standard. After all a P9 case, for example, is not cheap and when you have spent that amount of money you kind of resent having to buy this.
0
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
A
Andrew463 06.12.2014
Tough one to rate as it's just a plug... but if you have products from Mutable Instruments and others that require 5-Volt power it's a necessity for a Doepfer rack. It couldn't be any simpler to use, just plug it in and away you go.

Again, good value too.
1
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
HT
Get it for those hungry modules.
Harry Turner 02.11.2019
The Sub Harmonic Generator requires this.
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension