the t.bone CC 57

22

Condenser Microphone for Toms and Snares

  • Easy to mount on almost any drum due to strong spring-loaded rim clamp
  • Phantom power: 48 V
  • Frequency range: 30 - 20000 Hz
  • Characteristic: Cardioid
  • Impedance: 150 Ohm
  • Max. SPL: 136dB @1kHz
  • Signal to noise ratio: 63dB
  • Sensitivity: -46dB +/- 2dB
  • XLR connector
  • Gooseneck length: 10 cm
  • Dimensions clamp (L x W x H): 97 x 86 x 47 mm
  • Total length: 24cm
  • Weight: 130g
  • Colour: Black
  • Includes bag
Myynnissä vuodesta Helmikuu 2021
Tuotenumero 500012
Myyntierä 1 kappaletta
Incl. Clip On Mount No
Condenser Microphone Yes
Clip-On Microphone 1
Gooseneck 1
Näytä enemmän
45 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Maanantai, 6.05. - Tiistai, 7.05.
1

22 Asiakkaiden arviot

3.5 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Ominaisuudet

Ääni

Työnjälki

17 Arvostelut

MC
the t.bone CC 57
Mr. Clean 29.01.2023
I managed to get good sounds for toms. The arm is ok but the clamp is useless. They broke after two shows.

The springey thing is fine but the rubbers that holds it to drum fall off and then they wont stick anymore.

I hope they fix this , otherwice good affordable product.
Ominaisuudet
Ääni
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
F
Low cost greatness!
Flizz 21.06.2022
Great little microphone with amazing sensitivity. At this price range you really can't complain. I bought it purely to see if it could handle recording snares or toms and I'll definitely get more of these in the future. The input quality is very good.

What are the downsides? Although the material is quite strong , and the spring clip has a lot of pressure, it would have been better if the makers would have created something that can hook it self a bit better to rounded drum hoops. I found that adding some rough material to the hoop helps but not everyone will want to do that. Some hoops might not hold the clip... but in my case it works fine and does not fall off.

one more detail is that after a wile the microphone tends to go up a bit , so the positioning starts to change after a while, fixable problem but ... it shouldn't really happen. It could be that the longer i use it that it will stop doing that - Its a bit of stiffness issue .

but again , for this price range ... I'm forgiving and I do expect small things like these. I would suggest: try one before buying a load of them
Ominaisuudet
Ääni
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
R
Absolute garbage! AVOID!
Roadrunner39 30.12.2022
Well, where do I begin… over priced, thomann charge a ridiculous amount for postage!
The mic itself is built with poor quality plastic, the phantom power makes it hiss and the frequency response is awful for snare drums and toms! AVOID!
Ominaisuudet
Ääni
Työnjälki
2
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
HD
Punches way above their weight! However…
Hollowell Drummer 04.05.2023
I’ve purchased 3 of these so far for all of my Toms. I did a series of tests alongside some notable standard Tom mics and these held their own! I just finished recording the drums for my band’s new album and can’t be happier with them. However the largest problem is the mechanical design. I do NOT recommend clipping these right to a drum, instead you can find some cheap standard mic clips that fit the middle body and mount them on a mic arm. Mounting it this way enables the microphone to be positioned closer to the drum head AND with it being detached from the drum the angle of the gooseneck will stay in place. Warning though- don’t put the mic too close to the head or the sound will get too boomy. I’m also surprised with how decent the off-axis rejection is for being a condenser mic. I would buy them again and I like that they don’t cost a ton to replace if needed…however buy multiple mics at once since shipping is so costly!
Ominaisuudet
Ääni
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta