vpme.de ZeroScope

27

Eurorack Module

  • 2-Channel digital oscilloscope, frequency counter and tuner
  • Single, Dual and X-Y modes
  • Time axis adjustable from 10 μs - 10 s (10 microseconds to 10 seconds)
  • Voltage range adjustable from 0.5 - 10 V.
  • Hold mode
  • Power requirement: 30 mA (+12 V) / 10 mA (-12 V)
  • Width: 6 TE
  • Depth: 25 mm
Myynnissä vuodesta Lokakuu 2018
Tuotenumero 449099
Myyntierä 1 kappaletta
Switch Modul No
CV-Editor/VC-Processor No
Tools Yes
Width 6 TE / HP
179 €
Ilmainen toimitus sis. ALV:n
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu lähetyspäivä Perjantai, 26.04. mennessä
1

27 Asiakkaiden arviot

4.7 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Käyttö

Ominaisuudet

Työnjälki

20 Arvostelut

l
Small and useful
liimo 30.07.2020
Despite the small screen, the graph is very easy to read. Dual view gets quite messy, but at 6 hp, this can be forgiven.
Käyttö
Ominaisuudet
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
B
Esential tuner for beginner eurorack
Barret707 22.12.2021
I was debating shelling out for the Mordax DATA but there is nothing this little guy doesnt do for half the foot print that id use the DATA for.
Käyttö
Ominaisuudet
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
m
Excellent easy to use scope
mentok 10.07.2022
Very easy to use scope, controls are intuitive and integration within patches makes it easy. The V range is nice, I have a full-size scope near the rack that cost four times as much and most of the time end up just using this scope since it is designed _for_ eurorack voltages. Size is a benefit for smaller setups, but does come with the compromise of the smaller screen, but that should be expected. My only issue was the top M3 screws have a longer thread and thus cannot be replaced with knurlies and thus is the one module that requires a screwdriver. However, if installed in the right place (as it is in my setup) one should not need to worry about this after install.
Käyttö
Ominaisuudet
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
B
All is clarity
BenjaminRowlinson 14.09.2020
You can see what it does just by looking at it, and what it does it does as well as might be expected, given the tiny, monochrome, OLED. It is a shame that the sample-timing steps are so few and far between – as a result of which you're going to have to tune your sine waves to accommodate the machine if you're hoping to raise any stimulating Lissajous patterns from its XY mode – But stimulate they do. And it turns out that having an oscilloscope within easy reach at all times is even more useful than I'd anticipated. Had this thing on the 40U travelling essentials rack within minutes, right next to the ES-8, and I imagine it'll stay there for quite some time.
Käyttö
Ominaisuudet
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta