the t.bone MM-1

149

Measurement Microphone

  • Omnidirectional measuring microphone
  • Polarised 1/4" condenser capsule.
  • Polar pattern: omnidirectional
  • Frequency range: 20 - 20,000 Hz
  • Output impedance: 240 Ohm
  • Max. SPL: 132 dB
  • SNR: >74.9 dB
  • Phantom voltage: +9 V to +52 V
  • Weight: 188 g
  • Incl. holder and individual measurement protocol
katalógusunkba bekerült: Május 2006
Termékszám 190404
mennyiségi egység 1 darab
14 790 ft
ÁFÁ-val, plusz 6 900 ft szállítási költség
8-10 héten belül szállítható
8-10 héten belül szállítható

A termék hamarosan megérkezik raktárunkba, ezt követően rövid időn belül szállítható.

Szállítással kapcsolatos tájékoztató
1

149 Ügyfelek értékelései

4.3 / 5

A termékek értékeléséhez kérjük, jelentkezz be.

Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.

A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.

tulajdonsagok

kivitelezés

73 Vélemények

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
A
Good to EQ your speakers and to record with.
Anonim 27.12.2016
I use this microphone both to record and to equalize speakers with to eliminate peaks caused by resonances (both by rooms and by speaker cabs).

I've recorded some concerts and used it to record drums as a overhang microphone, for this it did sound absolutely accurate and nice, which is a good thing, as you're able to record it, sounding as realistically as possible, in my opinion atleast.

I've also used it to tune speakers for specific locations (because sometimes certain frequencies get boosted quite a bit, and to get it to sound as flat as possible), where it, again, in my opinion, absolutely does a good job.

Clarity:
I've absolutely got nothing to complain about, the fact it does only reach up to 18kHz isn't that much of a big deal to me as it's still a great sounding microphone doing what i'm using it for

Overall quality:
I really do like the nicely machined seamless metal housing, it appears to be very high quality, and sounds like it too.
tulajdonsagok
kivitelezés
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
R
Behri reference mic
RoadRunnersDust 26.09.2017
Best available Mic for use with SMAART, etc in its price range (and a good ways above its price range)
tulajdonsagok
kivitelezés
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
TM
Inaccurate calibration
Tomás Mulcahy 02.02.2024
I compared this to a Sonarworx microphone using Sound ID reference to calibrate speakers in an acoustically treated room. I had to very carefully enter the printed custom calibration graph as a list to make a calibration file for Sonarworx. The graph claims the mic is flat within 2dB for 85% of the spectrum.

However I got quite different results between the two mics. The T Bone produced quite a different curve above 2kHz which gave an audible difference. Sonarworx themselves confirmed that the cal file was fine so I can only conclude that does not match the microphone. Perhaps there was a mixup at the factory, or the mic's performance has degraded since I bought it in 2018.

The mic does sound flat when used for recording.
tulajdonsagok
kivitelezés
1
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
MP
Excellent for overheads
MC PityoPutyi 04.04.2015
That was funny I've looking for a cheap mic for recording cymbals on my drumkit. I've just went to Thomann list just as usual and put t.bone mics into the search box, then sign ascending order and I realize there is a measurement mic.

Uhh....I check the technical datasheet of that and it's frequency range was incredible....20Hz-18kHz and it's within +-3db in whole range...it's only going out at the low end...so I sad what else is better for cymbals.

Now I have it and I'll buy one more for my kit. There is nothing like hit this recording quality, frequency range and sensitivity around that price. I love it!
tulajdonsagok
kivitelezés
0
0
Jelentem!

Jelentem!