the sssnake Effect Pedal Adapter Straight

930

Jack Adaptor

  • For effects pedals and floor units
  • Straight design
  • Mono, 6.3 mm jack to 6.3 mm jack
  • Middle part 30 mm wide
  • Metal
katalógusunkba bekerült: December 2004
Termékszám 176150
mennyiségi egység 1 darab
1 055 ft
ÁFÁ-val, plusz 6 900 ft szállítási költség
Azonnal szállítható
Azonnal szállítható

A termék raktáron van és azonnal szállítható

Szállítással kapcsolatos tájékoztató
Szállítás megközelítőleg Csütörtök, 2.05. és Péntek, 3.05. közt.
1

930 Ügyfelek értékelései

4.2 / 5

A termékek értékeléséhez kérjük, jelentkezz be.

Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.

A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.

kivitelezés

291 Vélemények

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
s
It works, but it's not that compact
sontag 08.09.2014
This little gadget does its job, it connects two pedals and provides a crystal clear signal path.

I bought this and a slightly different offset adaptor (which allows for height differences) to use between boss and ibanez pedals, the only issue is with this device, is it requires a large space inbetween pedals, where as the offset connector does not. The resulting effect is a large gap, small gap etc etc between a line of pedals which does not look right, the way around this it would seem it to use multiple offset adapters, however when doing this the boss pedals form a zig sag pattern along the board, so there is no real solution using these straight through type connectors.

It works for a couple of pedals of the same manufacturer, but it doesn't simplify things if you have a big pedal board, you may even save space in the gap between pedals by using simple patch cables. Quality is good though, delivers what it says it will.
kivitelezés
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
A
Flawed by design
Algirdas 21.05.2013
It is pretty well made but has major flaws. For one, it cannot be used to connect pedals that have jacks not parallel to the floor. If that was the case, the adapter would put a lot of pressure on the jacks and damage the circuit boards that they're soldered to. The other disadvantage is that if you used these adapters to connect all your pedals and one of them broke down, you would have to remove all your effects from the board just to disconnect a single pedal. This adapter could be vastly improved by making its center section flexible. That way there would be no risk of damaging the pedals.
kivitelezés
1
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
T
Thumbs up
T.Azevedo 16.03.2020
I got this for free with a pedalboard i bought and this is nice to connect pedals if you can waste some space on your board.
kivitelezés
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
A
review of sssnake Effect Pedal Adapter
Andrew822 06.06.2013
Does the job but are a bit flimsy compared to other designs however you can get at the wire inside if ever you had to could attempt to repair them. Saying that they are that cheap that you can afford to have lots of spare replacements in your kit. If you don't use them roughly they will last a good bit of time.
kivitelezés
1
0
Jelentem!

Jelentem!