M-Audio SP-1

189

Sustain/Hold Pedal

  • Switchable
  • Cable length: 1.8 m
katalógusunkba bekerült: Augusztus 2007
Termékszám 118701
mennyiségi egység 1 darab
Polarity Switch Yes
6 099 ft
ÁFÁ-val, plusz 6 900 ft szállítási költség
Azonnal szállítható
Azonnal szállítható

A termék raktáron van és azonnal szállítható

Szállítással kapcsolatos tájékoztató
Csomagfeladás várható időpontja legkésőbb Péntek, 26.04.
1

189 Ügyfelek értékelései

4.3 / 5

A termékek értékeléséhez kérjük, jelentkezz be.

Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.

A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.

kivitelezés

94 Vélemények

P
Pyramid123 17.05.2020
Már régen ismerem ezt a terméket. Erősnek és strapabírónak tartom. Az alsó és felső gumiréteg jól a helyén van és jó a tapadása is. Most azért az SP-1 pedált rendeltem, mert egyik munkámhoz olyan pedálra volt szükségem, ami 0 vagy 127 értékű MIDI eseményt ad (nincs átmenet). Jó ár / érték arány. A kábel megfelelő hosszúságú.
kivitelezés
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
G
Not Working Well with KORG Kross SE-61
Gunawan 02.06.2020
I used this pedal for KORG Kross SE-61. I found a problem that sometimes the sustain pedal is not working. To solve this problem, I have to unplug and re-plug to the jack, or calibrate the half-damper function in the keyboard.
Actually, the pedal default polarity is same with KORG default polarity, and the pedal has a switch to change polarity.
kivitelezés
2
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
A
Basic sustain pedal
Anonim 03.03.2016
I purchased 2 of these to act as sostenuto and sustain pedals for the M-Audio Keystation Pro 88 and they do the job and work with a variety of devices - I've since replaced my M-Audio keyboard and replaced it with a Korg digital piano and my remaining SP1 performs admirably (I say remaining as my Korg only has one SP input).

What to get with the SP-1 is a basic package - a plastic, non-latching pedal with a rubberised base that basically switches from off to on (or on to off if you use the polarity reversal switch on the back - this is essential for some devices in order to get it to work in the traditional manner).

Years later, I'm still using this pedal for sustain but the sheet of rubber on the bottom has started to peel away and is difficult to get back on (it has little rubber pins that slot into the base). It has also developed a distracting squeak but I would expect that after years of use - that's nothing a bit of WD40 wouldn't solve!

My experience with the SP-1 is that it is an adequate pedal, gets the job done and, if in a pinch, I'd get one again. However, long-term I'd probably be inclined to get a more traditional single-unit setup instead of 2 separate pedals.
kivitelezés
1
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
A
Good and cheap
Anonim 11.11.2015
On/off sustain pedal with a polarity switch so it works with any keyboard with a sustain input. Length of the cable perfect, not too short, not too long. Feels like it would not break even when gigging with it.

What I received though does not look exactly like that in the picture, my version has those stripes in groups of three and the text "M-AUDIO" is black. But I don't think it matters.

It's good and cheap. I recommend.
kivitelezés
1
0
Jelentem!

Jelentem!