the sssnake Effect Pedal Adapter Straight

930

Jack Adaptor

  • For effects pedals and floor units
  • Straight design
  • Mono, 6.3 mm jack to 6.3 mm jack
  • Middle part 30 mm wide
  • Metal
K dostání od Prosinec 2004
Číslo produktu 176150
Prodejní jednotka 1 ks
63 Kč
Cena vč. DPH nezahrnuje poštovné 295 Kč
Na skladě
Na skladě

Tento produkt je na skladě a může být obratem odeslán.

Informace o expedici
Dodání přibližně v rozmezí Čtvrtek, 2.05.Pátek, 3.05.
1

930 Hodnocení zákazníků

4.2 / 5

Musíte být přihlášeni, pokud chcete hodnotit produkty.

Upozornění: Abychom zabránili tomu, že se budou hodnocení zakládat informacích z doslechu, polovičních pravdách nebo skryté reklamě, dovolujeme na našich stránkách hodnotit pouze skutečným uživatelům, kteří u nás vybavení také koupili.

Po přihlášení najdete také v zákaznickém centru v sekci "Hodnotit produkty" všechny produkty, které můžete hodnotit.

Zpracování

291 Recenze

MS
Dobrá redukcia.
Martin SE 17.11.2021
Ak chcem šetriť miesto v pedalboarde, a vyhovuje veľkosť, táto redukcia plní účel.
Odporúčam.
Zpracování
0
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
s
It works, but it's not that compact
sontag 08.09.2014
This little gadget does its job, it connects two pedals and provides a crystal clear signal path.

I bought this and a slightly different offset adaptor (which allows for height differences) to use between boss and ibanez pedals, the only issue is with this device, is it requires a large space inbetween pedals, where as the offset connector does not. The resulting effect is a large gap, small gap etc etc between a line of pedals which does not look right, the way around this it would seem it to use multiple offset adapters, however when doing this the boss pedals form a zig sag pattern along the board, so there is no real solution using these straight through type connectors.

It works for a couple of pedals of the same manufacturer, but it doesn't simplify things if you have a big pedal board, you may even save space in the gap between pedals by using simple patch cables. Quality is good though, delivers what it says it will.
Zpracování
0
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
A
Flawed by design
Algirdas 21.05.2013
It is pretty well made but has major flaws. For one, it cannot be used to connect pedals that have jacks not parallel to the floor. If that was the case, the adapter would put a lot of pressure on the jacks and damage the circuit boards that they're soldered to. The other disadvantage is that if you used these adapters to connect all your pedals and one of them broke down, you would have to remove all your effects from the board just to disconnect a single pedal. This adapter could be vastly improved by making its center section flexible. That way there would be no risk of damaging the pedals.
Zpracování
1
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
T
Thumbs up
T.Azevedo 16.03.2020
I got this for free with a pedalboard i bought and this is nice to connect pedals if you can waste some space on your board.
Zpracování
0
0
Ohlásit hodnocení

Ohlásit hodnocení